Topics

11

General Mach Discussion / Wrong working with Mach3.

« on: April 05, 2007, 07:12:11 PM »

Wrong working with Mach3.
Hello to all. As it is looked at frm the images, the circuit made with Mach3 is not correct and with greater circuits the errors increase. I enclose also the working file. Thanks in advance. Giordano

12

Finished Screens / Finished interface in Italian for Mach3

« on: September 10, 2006, 04:13:32 PM »

Hi to all. I have finished the translation of the interface of Mach3 in Italian. To decompress the files zip and to launch the program setup.exe.

13

Italian / Italian Screenset

« on: July 29, 2006, 02:36:23 AM »

Hi to all. I am making  translation in Italian of Mach3. Unfortunately I have some problems to translate you screen her Setting and Diagnostic. Can someone help? Thanks in advance. Giordano

14

General Mach Discussion / Help for macro probe

« on: June 11, 2006, 01:34:42 PM »

I have seen the video of the macro that concerns the use of a probe, but I have not understood well as to write this program. My probe is top 55,23 mm. Can someone help to write the proper macro? Thanks in advance. Giordano

15

General Mach Discussion / Execution intermittent.....

« on: May 20, 2006, 06:37:55 PM »

Hi to all. I have used the files attached interpcnc.iso (pcb project) in Mach3. But the execution is not fluid but intermittent and the padses are not sometimes aligned. The option Constant velocity in the menu Config | State is selected. The same files executed with Ninos 3.1 it is perfect. I prefer to use Mach3. Do you have a remedy? Thanks in advance. Giordano

16

Mach Screens / How to create of the buttons and of the labels with the text on two lines?

« on: May 18, 2006, 08:08:05 AM »

Hi to everybody. I am Italian. I would like to make the translation of the buttons and the labels used in Mach3. Is it possible to create of the buttons and of the labels with the text on two lines? Thanks in advance. Giordano

17

General Mach Discussion / Step per unit

« on: May 08, 2006, 07:46:11 AM »

Hi to all. I have read in a forum that the number in the playpen Step for unit it is critical. When Mach3  is installed this number is planned to 2000. I have a microstep controller RTA planned to 800 passi/giros and a screw with pitch 4mm. I have planned the number step for unit to 200. Is it correct? Thanks in advance. Giordano.

18

Mach Screens / Screen simplified set

« on: April 27, 2006, 06:46:01 PM »

Hi to all. I am Italian. The screens shown sets are all very beautiful ones. Can an easier interface be created where the text of the buttons and the labels is gotten by a files of resource so that each can translate it in her own language? is it possible to use the VB script editor? Thanks. Giordano

19

General Mach Discussion / Discontinuous execution of the contours

« on: April 27, 2006, 08:29:36 AM »

Hi to all. Since I had any losses of step, I have reduced the acceleration of the 10-20s motors mm s/s. As in the figure.
In this way the execution of a circle is not uniform anymore, but to hiccup. There is a cure. Thanks in advance, Giordano

20

General Mach Discussion / Written on aluminum

« on: April 14, 2006, 04:24:29 PM »

Hi. I would like to realize some writings on a panel in aluminum. Which is the good computer program that can work with Mach3?. Thanks in advance, Giordano.