Hello Guest it is July 21, 2019, 05:43:23 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - giordano

Pages: 1 2 3 4 5 6 »
1
NC Pod / Re: Ncpod is not recognized
« on: March 29, 2010, 05:37:20 PM »
Hello. Now use a card controlled by the parallel port, but if you improve the performance of my CNC I bought a card NCPOD. Could you help me understand how to make connections? I followed the two links below:
http://221.132.159.78/forme/up/ncPOD/00.pdf
Setting of Mach
http://221.132.159.78/forme/up/ncPOD/Mach3Mill.xml
but it seems not work. Could you send me the relevant files? Thanks in advance. Greetings. Giordano

2
Hello, I'm sorry but I did not understand the problem. I had not noticed this oversight. Thanks for reporting. Attach the file to install updates. After unpacking the archive, rename the file setup.dat to setup.exe. Regards, Giordano

3
Hello High Tech Key. To test, now I installed the translated version downloaded from the link provided and it works perfectly. Giordano

4
Finished Screens / Re: It can change the interface of the wizard?
« on: September 12, 2009, 04:41:45 PM »
Hello Ron. I created a new interface for Mach3, in Italian and English. I noticed that the wizard screens are a bit messy and I would like to modify them with the same style as the main interface. Regards, Giordano.

6
Finished Screens / It can change the interface of the wizard?
« on: August 01, 2009, 12:41:26 PM »
Hello to all. I can not change the files. Set in the Addons folder. It is not possible or am I wrong? Regards, Giordano Cantori

7
Hello to all. Now in most cases, are used lcd monitor at least 19 "that supports a resolution of 1280 X 1024. I would like to implement an interface with this resolution using Screen4. But setting this resolution, I noticed some problems. By setting a background image is not can be moved or changed. I led and the buttons can not be moved or sometimes disappear from. Am I wrong or Screen4 that does not support this resolution? Thanks in advance. Cantori Giordano

8
Hello to all. I finally finished the new interface in Italian for Mach3. To install unzip the file setup.zip and launch the program setup.exe. Regards, Giordano Cantori.

9
Hello, Chip. I you were a great help. Thank you very much. Regards, Giordano.

10
Hello, Chip. Very well done. Do you have a particular version or you have modified the original screen for Mach3? In my version, the 3,042,020 pins are not numbered and inputs 10,11,12,13 and 15 are arranged differently. You could tell me what the Code of OEM led each pin from n. 1 to n. 25 or, better yet, send me a copy of your screen? Regards. Giordano

Pages: 1 2 3 4 5 6 »