Hello Guest it is September 20, 2019, 04:25:02 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - geoff3881

Pages: « 1 2 3 4 5 »
31
General Mach Discussion / Re: Status error messages list.
« on: August 21, 2013, 04:44:19 PM »
It was the same PC that I am having problems with. ie. the one that drives the CNC mill

32
General Mach Discussion / Re: Status error messages list.
« on: August 21, 2013, 12:41:13 PM »
Thanks for the suggestions.
I can open both Turn & Plasma and do not get the error message. However, I cannot get any movement on XY or Z axes

33
General Mach Discussion / Re: Status error messages list.
« on: August 20, 2013, 01:55:16 PM »
You are correct in that it was working fine and then the error message came with no obvious cause. I copied the xml file from the workshop PC which is only used to run the CNC machine.
Not sure what you mean by loading a different profile from the Mach loader ?

34
General Mach Discussion / Re: Status error messages list.
« on: August 20, 2013, 11:55:20 AM »
Its Mach 3 2.0 installed around 2007

35
General Mach Discussion / Re: Status error messages list.
« on: August 20, 2013, 05:08:07 AM »
Thanks for response File att.

36
General Mach Discussion / Re: Status error messages list.
« on: August 19, 2013, 08:48:57 AM »
I have just run the driver test. It says "System under Mach3 control"
Fastest time 101483
Slowest time 101463
No reading in pulse /sec window & no graph
I seem to remember previous tests had a pulse /sec reading

37
General Mach Discussion / Re: Status error messages list.
« on: August 19, 2013, 03:39:13 AM »
Does anyone have any suggestions on how to proceed logically to investigate the cause of the error message ? Any help appreciated.

38
General Mach Discussion / Error Messages
« on: August 18, 2013, 01:20:14 PM »
Did anyone come up with a list of error messages ? When starting Mach mill I get "Error triggered" and cannot proceed. I have also had "Error stopping timer" Does anyone have suggestions for a fix ?

39
G-Code, CAD, and CAM discussions / Re: AutoCAD - LazyCAM - G Code
« on: July 01, 2009, 03:20:49 AM »
TP, I had a try, but without sucess. I then took a look at the LazyCAM video on the Mach site and noticed that the screens and layout look very different to mine. I have Mach R2.0.025 and LazyCAM 2.00 020 std. Do I need an update ?
The video seems to show a reasonably flexible ability to rearrange layers, chains, entities etc. Whilst I am stuck on a very basic issue !  Thanks  Geoff

40
G-Code, CAD, and CAM discussions / Re: AutoCAD - LazyCAM - G Code
« on: June 29, 2009, 02:53:12 AM »
I have tried drawing the item in the order of cut, but even with a simple form it's not very convenient. Tangential lines eg. need the circles before the tangential lines. You can fiddle around with construction lines etc., but it's not ideal.
Do you know how to rearrange them in LazyCAM after completion of the CAD profile ?
Thanks for your interest   
Geoff

Pages: « 1 2 3 4 5 »