1
General Mach Discussion / Works in KCam, Not working in Mach3
« on: February 28, 2007, 05:28:16 AM »
Dear All,
I bought my cnc controller yesterday and i connect everything as in manual. The board works very well in Kcam (Kcam is explained in manual and i configured this program works very well). But i would like to buy Mach3 and so i need to configure it for Mach3. I took this ss from related softwares :
Mach3 : (Not Working)
KCam : (Works well)
So, what's the point? What is wrong with these configuration?
TIA
Cooper
I bought my cnc controller yesterday and i connect everything as in manual. The board works very well in Kcam (Kcam is explained in manual and i configured this program works very well). But i would like to buy Mach3 and so i need to configure it for Mach3. I took this ss from related softwares :
Mach3 : (Not Working)
KCam : (Works well)
So, what's the point? What is wrong with these configuration?
TIA
Cooper