Messages

291

G-Code, CAD, and CAM discussions / Re: Simple M6 Manual Tool Change

« on: April 23, 2019, 07:59:10 PM »

On settings page there are three DROs for tool change location. They are in Machine Coordinates!!!
Machine should go to that location when Mach encounters M6 Tx.

292

G-Code, CAD, and CAM discussions / Re: Mach 3 - How to Recover the Z height after a failure

« on: April 21, 2019, 04:06:13 AM »

A lot of projects in which material? Wood/Metal/Plastic/Foam...
As you are removing top of entire material, you should reference your machine to the machine bed.
Also in your CAM you should set Z datum to the machine bed. Then you are trouble free regarding your 3D (2.5D ) projects.

293

General Mach Discussion / Re: Big Tex screen set

« on: April 13, 2019, 01:33:46 PM »

Used to have 3.2 but then i bought from Big-tex 3.4.
Unfortunatelly, I deleted 3.2 installation

If I find it, I will put 3.2 here

294

Forum suggestions and report forum problems. / Registering to forum Captcha sucks

« on: April 09, 2019, 03:07:39 AM »

As per subject.
Captcha should be more complicated one. I just logged off, tried to register a couple of times, just to see how easy is to create an account. It was enough to click on "I'm not a robot" and ... spamer goes through.
Hope that someone will fix this problem (NFS)

 

295

G-Code, CAD, and CAM discussions / Re: Feed Rate mm/sec to mm/min

« on: April 05, 2019, 07:53:01 AM »

https://forums.autodesk.com/t5/hsm-post-processor-forum/feedrate-units-adjustment/td-p/8514266

296

General Mach Discussion / Re: Goofy forum layout

« on: March 29, 2019, 06:33:17 PM »

https://www.machsupport.com/forum/index.php?topic=39758.msg266672#msg266672

 

Thanks
Had to digg again through options.
I prefer "old look".

297

General Mach Discussion / Re: Goofy forum layout

« on: March 29, 2019, 02:10:33 PM »

Is smf theme gone for good?
I hate the youtube video which is, even paused, downloading in background. It's annoying.
Here are forum users that are not so lucky as Stuart with 350mbps unlimited bandwidth.
If users prefer to watch youtube videos, they will visit tube directly.

298

*****VIDEOS***** / Re: Greeting from Tokyo Japan

« on: March 29, 2019, 04:53:22 AM »

Very nice Yoshii.

299

General Mach Discussion / Re: Dragon Project

« on: March 23, 2019, 09:13:19 AM »

Nice

300

General Mach Discussion / Re: Software stops mid opperation.

« on: March 15, 2019, 11:59:35 AM »

Craig my post was directed to @reuelt.