281
General Mach Discussion / Re: Nema34 to Mach3 IB connected to DQ860MA
« on: May 03, 2019, 02:45:55 AM »
You did not connect Enable
One side is connected ti +5V and other?
One side is connected ti +5V and other?
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
When Windows 7 boots up, it usually INITIALIZE the parallel port.This was your first sentence, so external motion controllers are out of scope of your writing (I guess )
What would prevent a spammer from flooding the New Member request bay ?Nothing, but the spammer will stay in "noman's land"
If GetOEMLED(801) Then
Code "G53 G0 Y1"
Else
Code "G53 G0 Y25"
End If