Hello Guest it is March 28, 2024, 04:23:20 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ZASto

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 »
271
General Mach Discussion / Re: 6040 cnc depth of cut and z zero
« on: July 23, 2019, 03:48:18 AM »
Z axis calibration? (steps per)

272
General Mach Discussion / Re: Coolant for CNC router motor.
« on: June 22, 2019, 11:18:42 AM »
@marsh4120: Spindle motor is water cooled:)

@richag77: You can use antifreeze solution. It has rust inhibitors.

273
I suspect on a bad hardware, most probably RAM. Try to pull out RAM modules and plug them back tho their sockets.

274
Show"N"Tell ( What you have made with your CNC machine.) / Quick test
« on: June 17, 2019, 09:28:19 AM »
2.5W blue laser, quick test on DIY machine :)

275
General Mach Discussion / Re: My stepcraft DL445 laser leaves a path
« on: June 12, 2019, 03:36:43 AM »
Google is your friend. Searching for "vectric laser post processor" gives as a first hit:
https://jtechphotonics.com/?p=3851

276
Modbus / Re: Arduino Modbus, Complete, Documented and free
« on: June 05, 2019, 03:10:02 PM »
CRC16.cpp:16:22: fatal error: WProgram.h: No such file or directory

Bolded should be changed with Arduino.h if you use newer version of compiler.

277
Im Motor tuning, check Step and Dir pulse width. Last week a frend of mine was complaining about the same thing. Pulse widths should be at least 5us. All is dependent on drivers that you use. Some 2 and 4 axis chineese driver boards do not like short pulses.

278
General Mach Discussion / Re: Lines in finished Carve
« on: May 20, 2019, 06:53:50 PM »
Is 1/16 tip diameter?
If yes, you should take smaller step over.

279
I like new system of approval :)
A bit of work for mods but spam free.

;)

280
Tangent Corner / Re: The Birds rule.
« on: May 12, 2019, 02:13:31 PM »
ROFL  :D

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 »