Hello Guest it is March 29, 2024, 08:07:13 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ZASto

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 »
161
Seems that your old license got corrupted during copying..
Glad you sorted it out.

162
It stops, but it does not replicate line #5000 until the end of time :)

163
GCode window without and with license, no differences. W/O license Mach should stop at line N5000, have not tested :)


164
Tweakie, it is visible on the screenshot that the license is present: Richard Lowe

165
What is your Mach3 version?

On Version R3.043.062 everything looks fine.
Attached is code from your .pdf

166
General Mach Discussion / Re: I need help with e-stop
« on: May 29, 2020, 07:32:38 AM »
In any case, when you disengage EStop, you should reset Mach and rehome the machine.
Safe enough?

167
General Mach Discussion / Re: Homing double touch the home switch
« on: May 27, 2020, 01:35:33 PM »
The button editor says DoButton (24)  DoButton (23) DoButton (22) 
This is what i get when I do that.
And you an write code in the opened window.
DoButton (24) homes Z Axis,
DoButton (23) homes Y Axis,
DoButton (22) homes X Axis.

Try to find "Mach3 V3.x Programmer Reference Draft v0.11a.pdf"
It exists somewhere on this forum as an attachment.

168
General Mach Discussion / Re: Homing double touch the home switch
« on: May 27, 2020, 04:13:38 AM »
DoButton is not a script.
To edit button, go to: Operator -> Edit Button Script, then click on your REF ALL HOME button.

169
You should be able to run demo, as far as I know, demo is limited ti 500 lines of code (50 in turning).

Have you installed all relevant drivers for your hardware?
Did you try to run DriverTest? It is locateed in Mach3 folder.

170
General Mach Discussion / Re: I need help with e-stop
« on: May 23, 2020, 08:39:43 AM »
Glad you figured out :)

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 »