Messages

121

General Mach Discussion / Re: Years on now Mach 3 is dropping out on me? Screenset 2010

« on: October 24, 2020, 02:32:17 AM »

Are you aware that Mach3 development ceased 6 years ago?
No bug fixes anymore. No ANY improvements anymore.

You have to learn to live with its quirks and workarounds, or change the machine controlling software.

122

General Mach Discussion / Re: Mach 3 Programming Question

« on: October 23, 2020, 12:46:13 PM »

It simulates normally.
Two passes over same geometry at 0.0625 and 0.125 depth.
Could not find any errors in your code.

123

General Mach Discussion / Re: usb moyion controller

« on: October 21, 2020, 12:32:29 PM »

Tweakie had a hickup
TPS provided link ti thread.

124

General Mach Discussion / Re: "Motor Tuning" not opening in Mach3

« on: October 15, 2020, 03:23:57 AM »

I had similar problem and reinstalling Mach3 fixed it.
Try, it cost nothing.
All of your data will be there as the reinstall does not delete any of your settings, macros, screen sets, ...

HTH

125

General Mach Discussion / Re: touch probe install on mack 3

« on: September 24, 2020, 10:26:07 AM »

Config -> Ports & Pins -> Input Signals
Check the state of Probe input. If needed, check Active Low to reverse behavior of your probe.

126

General Mach Discussion / Re: Auto Z Probing retract height

« on: September 24, 2020, 09:46:13 AM »

Settings/Ports & Pins/Input Signals...
Change the state of Probe pin (if Unchecked Active Low check it, and vice versa).

127

General Mach Discussion / Re: Demo version

« on: September 20, 2020, 04:33:46 PM »

Well, your laser, if it is blue/violet one, needs 12V supply and PWM for power regulation.
12V from a dedicated power supply, PWM signal from your controller.

128

General Mach Discussion / Re: Demo version

« on: September 20, 2020, 10:50:53 AM »

If your board has PWM output, connecting laser should be easy.

129

General Mach Discussion / Re: NEED HELP!!! Setting up Mach3 with Gecko G320X and servos for a 3-axis router?

« on: September 14, 2020, 02:04:52 PM »

Which controller are you using?
As tps wrote, some *********ography please

130

VB and the development of wizards / Re: Auto Tool Zero without Z surface

« on: September 13, 2020, 06:35:38 AM »

The easiest way is to use 2 (two) touch plates. One movable for setting first tool on top of your material and one atfixed position to measure each subsequent tool when you don't have the same Z0 level due to first carving.
All of that can be found in Big-Tex tool setter screen set.
Search this forum, I've posted a link for download.