Messages

21

General Mach Discussion / Re: taig mill

« on: November 25, 2006, 07:45:49 AM »

southport merseyside
we are the jewellery workshop

22

General Mach Discussion / Re: taig mill

« on: November 25, 2006, 07:35:55 AM »

thanks hood im watchin the vids
would like to purchase but need to know a bit more
ciao f now

23

General Mach Discussion / taig mill

« on: November 25, 2006, 07:13:44 AM »

hello folks
complete newbee to the forum
i have been running a taig mill for two years on the mps2003 programme and have been a little downhearted with the lack of control
not that I'm an experienced engineer, quite the opposite  i am a designer and relatively new to engineering.
we are a UK based company and  have been using artcam software to create jewellery which is a fantastic programme and the taig mill is adequate for our use as most of the stuff we produce is wax so we are not really dealing with torque so much, we also use mills from bits and bits in the US.
when i saw the Mach 3 programme i thought i should give it a whirl ,however it seems a little complex so Ive got my head down in the pdf manual so i might be some time ....................
my question is if anybody is or has used taig mills with Mach 3 and if so could i be setting the pins wrong or something as i cant seem to get any com/ control 
i would appreciate any feedback at all