Hello Guest it is March 29, 2024, 03:41:35 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Freff

Pages: « 1 2
11
General Mach Discussion / Re: Wizard Inaccuracies
« on: September 11, 2008, 05:20:50 PM »
Hi Hood and thanks for your quick reply. I commanded G0X2 and the axis moved about 1mm. not 2".
If I run any other Gcodes for example ones I have created myself in Lcam eg. then they come out fine.

12
General Mach Discussion / Wizard Inaccuracies
« on: September 11, 2008, 04:36:47 PM »
I have just started using Mach3 R2.63 (licensed) with the come with wizards. To get some experience I have started using the wizards, the Circle Cut to be a good starting element. All the settings I entered came out on the work piece Ok except the diameter.

No matter how many times I tried the diameter always come out different to the setting I entered. Not only that they are randomly different. I have tried the circular pocket and the results are the same, always the diameter.

I'm sure that I'm entering all the settings correctly, but I'm possibly missing something. Could someone please point me in the right direction, it's getting very frustrating.

Many thanks
Tony

Pages: « 1 2