Hello Guest it is March 28, 2024, 08:57:37 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - keithorr

Pages: 1
1
General Mach Discussion / Update Tool Data using G10?
« on: February 26, 2008, 10:14:29 PM »
I am using a surface grinder and would like to update the wheel z height after dressing.

I know how to set the tool height while running a program:

G10 L1 P1 Z1.000

Is there any syntax to update the Z value after I have removed .004 from the wheel radius? I've tried Z=(Z-.004), Z(Z -.004) etc

I'm looking around but not finding a parameter value that "might" work.

Thanks

Pages: 1