31
General Mach Discussion / x and y movement confusen
« on: December 17, 2013, 03:04:13 PM »
I am confused of the movement on my mill. (Mach 3 settup) I espect the spindle to go to the left (+ postiv dir.) when I press the left arror, put +10x in the dro and then "go to zero" and put g0x10 in the MDI. The same in the y direction (+ posetiv dir. away from me {or up}).
But this is what is happening in the x dir.:
Press left arrow spindle move to left (OK)
Enter +10 in x DRO, spindle move to left (OK)
Enter g0x10 in MDI, spindle move to right (?)
In the y dir, this is what happen:
Press up arrow spindle move up (OK)
Enter +10 in y DRO, spindle moves down (?)
Enter g0y10 in MDI, spindle moves up (OK)
How can I correct this? My mill is working well, but it is confusing to remember this and its easy to go wrong.
Thanks for any help
Johannes
But this is what is happening in the x dir.:
Press left arrow spindle move to left (OK)
Enter +10 in x DRO, spindle move to left (OK)
Enter g0x10 in MDI, spindle move to right (?)
In the y dir, this is what happen:
Press up arrow spindle move up (OK)
Enter +10 in y DRO, spindle moves down (?)
Enter g0y10 in MDI, spindle moves up (OK)
How can I correct this? My mill is working well, but it is confusing to remember this and its easy to go wrong.
Thanks for any help
Johannes