Messages

11

VB and the development of wizards / How to set the feedrate with a button

« on: March 05, 2013, 04:35:36 PM »

I want to set a new feedrate in the middle of a running program with a button.

Example:

The feedrate is a 1000mm/min in the middle of running program.
When i push a button (make in a new screen) the feedrate must be 10 mm/min.
When i push the button again the feedrate must be previous feedrate.

All this without stopping the running program.

12

General Mach Discussion / Re: 4th Axis move after feed hold

« on: March 04, 2013, 04:42:24 AM »

I have the same problem on 6 different milling machines.
When i push on feedhold and make a restart the 4th axis is running.

The problem only appears  when i make a feedhold when the z-axis is moving.

A bug maybe?

13

Brains Development / Re: Trigger an output when axis is moving

« on: November 10, 2012, 04:58:10 AM »

I will give it a try.

The steppermotor on the a axis is 50 Nm and when you let the a axis move with the break on there are no loss of steps.

14

Brains Development / Trigger an output when axis is moving

« on: November 07, 2012, 01:02:04 PM »

I have the following problem.

On a wood milling machine i have a A axis with the spindle mounted on.
The A axis has an air break controlled by a solenoid.

So when i move the A axis the break has to release.
How can i make that possible?

Vb script or brain?

15

PoKeys / Re: New PoKeys56U was released!!

« on: September 15, 2011, 04:23:46 AM »

Thanks

16

PoKeys / Re: New PoKeys56U was released!!

« on: September 15, 2011, 03:40:38 AM »

And what about the plugin for mach?
I could not found a plugin anymore on the pokeys website.

17

PoKeys / How to use 25 inputs and 22 outputs with pokeys?

« on: March 07, 2011, 01:04:15 PM »

Hello,

I want to use 25 inputs and 22 outputs with the pokeys.
The configuration in pokeys is not the problem.
But now i want to use it in brains or a vb script.

How can i do that?

18

Show"N"Tell ( What you have made with your CNC machine.) / Re: compressed air engine

« on: March 11, 2010, 01:49:19 PM »

Here is another picture.
This is the rotor with shaft and bearings.

19

Show"N"Tell ( What you have made with your CNC machine.) / Re: compressed air engine

« on: March 11, 2010, 01:46:37 PM »

It took time to make some pictures.

Here a picture of the housing.

20

Show"N"Tell ( What you have made with your CNC machine.) / Re: compressed air engine

« on: March 01, 2010, 02:18:22 PM »

This is the next one i build.
The housing and the rotor are made on the cnc machine.

http://www.youtube.com/watch?v=EXMdIwZso7U