Hello Guest it is May 30, 2024, 03:48:11 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - tripleblack

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 »
91
PoKeys / Re: setting up input for oemcode
« on: December 01, 2009, 07:23:19 PM »
hi Boris, anything on the setting file?

92
General Mach Discussion / advanced threading plugin
« on: November 26, 2009, 03:58:18 PM »

i am trying out threading on my chnc hardinge retrofit. have the latest update of mach3 installed. i have created the threading code with the simple threading wizard. with the advanced threading plugin enabled,the x and z move to the start position and does not proceed . on the advanced threading screen, shows awaiting trigger. whats the trigger?

93
PoKeys / Re: setting up input for oemcode
« on: November 26, 2009, 09:43:54 AM »
thanks for the info . i found the selection of the pendant . but in the pokeys setup , is the input set for app or just left as none?

94
PoKeys / setting up input for oemcode
« on: November 25, 2009, 02:06:30 PM »
i am trying to set up the pokeys to do the following.i have two momentary buttons along side of an mpg. one button i wish to select the x axis, the other select the z axis.
i have set up oemtrigger 1 to be oemcode 59 for the x axis. oemtrigger2 is oemcode61 for the z axis. i have in ports and pins, oemtrigger1 port 10  pin1. oemtrigger2 port 10
pin2. how is the pokeys setup for this? i see in the pokeys software to set pin 1 as an input, pin2 as an input, but what after that? as a macro? keyboard shortcut? i am confused.

95
General Mach Discussion / Re: List of suitable PCI parallel ports
« on: November 18, 2009, 01:42:20 PM »
with the moschip pci try the 9735 driver. i think that was the one that worked for me.

96
General Mach Discussion / Re: List of suitable PCI parallel ports
« on: November 18, 2009, 12:45:39 PM »
have you tried the output pins on it at all? set an output pin to port2 pin14 and test with a voltmeter  if it is switching on.is the port address correct?

97
General Mach Discussion / Re: List of suitable PCI parallel ports
« on: November 18, 2009, 10:29:51 AM »
try reinstalling a different driver. perhaps the 9815 driver. in mach3 do you have inputs enabled?

98
General Mach Discussion / Re: List of suitable PCI parallel ports
« on: November 18, 2009, 06:42:11 AM »
hi, i have tried the startech card also with no success. you need a card that uses a moschip 9805,9815.also called netmos. i buy them at tigerdirect. about 20.00

99
General Mach Discussion / Re: Smoothness EXTREME need of help
« on: November 12, 2009, 08:55:06 PM »
try changing the cv distance tolerance to .1 , and the stop cv on angles to 89 in general config.also depending on your speed and toolpath , polylines instead of arcs work more smooth.

100
General Mach Discussion / Re: dro at startup
« on: October 09, 2009, 07:29:52 AM »
thanks Hood. that solved my problem.

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 »