Messages

11

General Mach Discussion / Re: servo drive connection

« on: April 09, 2007, 06:44:27 AM »

Thanks Brian
I will just have to wait for a link.I need so get the machine back up and running ASAP.
It would be handy if someone in Scotland could come in and do the connection as I'm
not very good with electronics
Regards
Brian Reid
Reid Engineering
Dundee

12

General Mach Discussion / servo drive connection

« on: April 08, 2007, 09:51:35 PM »

Hi,
I need some advice on connecting my Norwin drive to my pc to run on Mach3.
where do I connect to the drives (pic of cover attached) to my parallel cable.
I tried pin 2 and pin 3 to comd - and comd + without any joy.Its a Boxford ACL lathe
and the old ANC control is done.
thanks
Brian