Guest
Show Posts
21
Works in progress / Re: Conversational Wizard/Screen set for Mach
« on: December 27, 2008, 06:07:05 PM »
Well...Scott,
I just posted this over on the CNCZone forum yesterday. I had not seen this thread yet.
I have started working on some wizard screens on my own....actually a take-off from the work I have been doing on a customized screenset of my own.
This first one is a single wizard to do 5 different circle routines on one page. I tried to make it as easy to follow as a Bridgeport EZ-Trak screen.
Let me know if this along the line of what you had in mind.
It is designed for a 1280 x 1024 Screen Resolution but scales down reasonably well using the "Auto Screen Enlarge" button on the general config page
I just posted this over on the CNCZone forum yesterday. I had not seen this thread yet.
I have started working on some wizard screens on my own....actually a take-off from the work I have been doing on a customized screenset of my own.
This first one is a single wizard to do 5 different circle routines on one page. I tried to make it as easy to follow as a Bridgeport EZ-Trak screen.
Let me know if this along the line of what you had in mind.
It is designed for a 1280 x 1024 Screen Resolution but scales down reasonably well using the "Auto Screen Enlarge" button on the general config page