Messages

21

General Mach Discussion / best way to restart program after accidental Estop

« on: November 10, 2006, 08:48:18 AM »

We need to restart at the stopped position and continue the program. Do not have line numbers as were told Mach2 does not like line numbers(on one of the posts) . It is a problem to not restart at the stop point as we are in the last 20% of the cut. TNX rdd

22

Polls / Re: What version of Mach are you using?

« on: November 07, 2006, 05:07:01 PM »

We are using MAch2 will upgrade as soon as the router mfg gives us the post file to setup, I figured that we would have to do the setover in the BobCad/cam as the G code was generated in that program. I really appreciate your help TNX

23

General Mach Discussion / How to input the setover for the routing tool

« on: November 07, 2006, 02:26:41 PM »

Am having trouble getting the setover of a .250 ball end cutter setover (0.125").  I want the setover to be around 0.050". Can not tell where or the settings or offsets are to be used.  Can I do this in Mach2 or must I go back to the BobCad program to do the reset to a smaller setover, Help anyone!

24

General Mach Discussion / Need in house help with setups

« on: November 01, 2006, 03:33:37 PM »

  We need some help to expedite the setup of a small router system using Mach2/3. Located between CLE and Pittsburgh. Willing to pay for on site help. Must have current working experience with setup and programming.  Contact via email consultrdd@koolisp.com.

25

General Mach Discussion / Re: Beginner needs help W/ Mach 2 Mill

« on: October 30, 2006, 07:56:26 PM »

Have just purchased Shark CnC machine trying to load Mach2 Mill, need the sequence to load the postprocessor supplied by Shark after loading the Mach2 install, Need the step by step if possible. Also would like to find someone who has used the Shark machine and  could give us some support (will compensate for help)