Messages

21

General Mach Discussion / Re: Hardware suggestions?

« on: July 27, 2008, 01:42:51 PM »

This is a Bridgeport "Boss" (R2E3) mill.  For those not familiar with these machines, it is factory built as a 3 axis CNC.  It uses 140 volt brush type DC servo motors.  In terms of size, it is pretty much equivalent to the manual Bridgeport "Series 1" that everyone is familiar with.

I am in the US (Oregon).

Thanks
Scott

22

General Mach Discussion / Hardware suggestions?

« on: July 27, 2008, 04:41:30 AM »

Is there a sticky post or FAQ or something of the sort that describes the various pieces of hardware necessary to create a working cnc system using Mach ?  I want to retrofit a mill for 3 or 4 axis machining.

Thx
Scott Kelley