Hello Guest it is March 28, 2024, 03:23:31 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - sanel_bico

Pages: 1
1
General Mach Discussion / Need help for motor tuning
« on: November 17, 2005, 02:27:04 AM »
 Hi,
we are new users of Mach software. We have problem with one axis on our plasma cutting mashine. On this axis we have small ratio portion and motor need only few steps (7) to make one unit (1mm). I case that we using these number of steps we have very noisy moving. Some other software like TurboCNC or EzCNC have smooter moving on same machine.
How we can solve this problem?

Thanks

Pages: 1