Topics

1

General Mach Discussion / Configuration Issues

« on: July 25, 2008, 01:32:29 PM »

I am trying to run a single stepper motor using Mach3, but I can't get the motor to run.  I am using a Campbell breakout board and a Geckodrive G203V driver with my motor.  I can't get the motor to respond to any Mach3 commands, but when I turned off the power to the breakout board and driver while Mach3 was still running, the motor turned a little bit.  It seems that things are hooked up, but I don't have Mach3 configured correctly.  Does anyone have any ideas on fixing this problem?