Messages

101

General Mach Discussion / Re: Inverting display toolpath screen

« on: July 19, 2008, 09:48:23 PM »

I'm not quite sure that I follow you.  But I think that you are saying that there is no way to rotate the Mach toolpath screen, Correct.

Thanks,Tom

102

General Mach Discussion / Re: Inverting display toolpath screen

« on: July 19, 2008, 09:27:48 PM »

The reason that I wiant to rotate the screen is that I have my CNC setup that way with the home position in the upper Right.  I can make do with it the way it is but for clarity when setting up it would be nice to have the screen view the same as the cnc is layed out. Thanks for the reply.

Tom

103

General Mach Discussion / Inverting display toolpath screen

« on: July 19, 2008, 08:29:05 PM »

Hi, I am new to Mach3 but I am not new to CNC.  My question is there a way to have mach3 display the toolpath screen having the 0,0,0 Home position in the upper right hand corner instead of the lower left corner? I basically want to have it display rotated 180 degrees from its default position.

Thanks,Tom