Hello Guest it is February 24, 2024, 05:32:19 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - cap232

Pages: 1
1
SmoothStepper USB / Re: Hi/Low Current
« on: December 27, 2009, 04:30:55 AM »
Hi

I write to Greg Cary

And he quickly write back, that he need to add that feature to the SmoothStepper plugin.

And will try to do it this week

Thanks  Greg   :) :)

2
SmoothStepper USB / Hi/Low Current
« on: December 25, 2009, 05:52:23 AM »
Hi
Can someone help me ??
When I run Mach3, direct on the lpt, my motor control goes Hi/Low Current fine.
But when I use Smoothstep v 1.2 Hi/Low Current don’t run ????
I use the same setup in Output Signal (see the attach file)
When I change Active Low Status in the setup I can get the,[img]http://Hi/Low Current to change,
But I cannot get it to change automatically like when I run direct on my LPT port. ???

Pages: 1