Messages

11

General Mach Discussion / Re: z-axis problem

« on: June 30, 2008, 08:24:02 PM »

yes im runnin two profiles and i did check moter tunning and there the same in both profiles. i dont have config issue on my screen

12

General Mach Discussion / Re: z-axis problem

« on: June 30, 2008, 08:14:28 PM »

where do you find the microsteps in mach

13

General Mach Discussion / Re: z-axis problem

« on: June 30, 2008, 08:12:35 PM »

thanks brett for your quick respond . no this isnt a new setup it was workin fine on friday but today its got the monday blues , this machine is a plasma/router table when i run it in plasma everythin is fine but not in routerin

14

General Mach Discussion / z-axis problem

« on: June 30, 2008, 08:02:57 PM »

hi folks,im new here.im having a problem with mach3. when i zero my x axis and then i jog it up by say .378 it moves 3.78 on the dro so when i run code i dont get the right depths any ideas thanks