Hello Guest it is April 24, 2024, 02:13:18 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - i-marc

Pages: 1
1
General Mach Discussion / Mach3 rouns corner when running fast X,Y feeds
« on: June 30, 2008, 04:43:48 PM »
I have been running Mach 3 ver 1.84.001 for a couple years…love it but recently have been dramatically increasing my X,Y feeds to 250 ipm for melamine and am noticing  that the inside and outside corners of my parts are being rounded off. I have to eliminate this problem. Any body have some ideas. Much appreciated.

Pages: 1