But did you actually get the machine to move with camsoft? Are you running Servos or steppers?
I had a little experience with Camsoft. I finally got it to run pretty well with steppers on a bridgeport series rigid ram. I had to do alot of tweaking within Galil Terminal. The reason I did not stick with it was Camsoft wanted Thousands of dollars per year for licensing and there support people were very rude.
I switched to a software called WINGCNC. Ran it for about 10 years. After 3 years of my equipment being in storage I am now making the move to Mach3. I do not have to worry about lost production time this time around.
I am finding it to be quite a challenge to figure out using old Galil products and Mach3. But it is not the problem of Mach for the most part. It is getting the old Galil stuff to work on newer OS.
I have on ISA bus machine and I can not get the 1740 card to register properly in XP PRO to save my A$$