961
General Mach Discussion / Re: Threading reboot
« on: March 25, 2016, 09:19:51 PM »
- Use spindle feedback in sync mode should be checked in Spindle setup
- Ok to also check spindle speed averaging
- make sure the index is enabled and uncheck emulated, may want to and try active low for the index for the input signal. Pin 10-13 and 15 are inputs to Mach thus 13 should be ok.
- Timing should not be enabled
- No Turn Diagnostics should be enabled in plug in control
- OH, BTW, need to turn on the spindle in lathe to have RPM show......
RICH
- Ok to also check spindle speed averaging
- make sure the index is enabled and uncheck emulated, may want to and try active low for the index for the input signal. Pin 10-13 and 15 are inputs to Mach thus 13 should be ok.
- Timing should not be enabled
- No Turn Diagnostics should be enabled in plug in control
- OH, BTW, need to turn on the spindle in lathe to have RPM show......
RICH