7141
General Mach Discussion / Re: dxf files for Turn
« on: September 11, 2008, 09:26:09 PM »
spnar,
I thought I would help you help yourself to generate some code for that lathe of yours using the Wizards.
Attached is a little tutorial on how to use one of them. This way you can get all the gcode you want
to play around with and learn some things at the same time.
Also attached is a DXF file for one of the pulleys made for a scale model. You can see the finished piece using the link below.
The gcode was generated by Lazcam and cut using MACH Turn. I will look for a file I have somewhere on getting
started with Lazcam.
RICH
http://www.machsupport.com/forum/index.php/topic,8195.msg51833.html#msg51833
I thought I would help you help yourself to generate some code for that lathe of yours using the Wizards.
Attached is a little tutorial on how to use one of them. This way you can get all the gcode you want
to play around with and learn some things at the same time.
Also attached is a DXF file for one of the pulleys made for a scale model. You can see the finished piece using the link below.
The gcode was generated by Lazcam and cut using MACH Turn. I will look for a file I have somewhere on getting
started with Lazcam.
RICH
http://www.machsupport.com/forum/index.php/topic,8195.msg51833.html#msg51833