5801
Show"N"Tell ( Your Machines) / Re: CNC CONVERSION - 6" ATLAS LATHE
« on: September 03, 2009, 08:31:28 AM »
Russ,
I am not sure, yet. Will add wipers to the ball screw but that dosn't cut it. Maybe bellows or hard covers or a combination of both. Design yet to be done! At this point still have plenty of time to think of it.
Collection, ha....ha.... i need to get rid of stuff, as the shop is full.
What did you do?
RICH
I am not sure, yet. Will add wipers to the ball screw but that dosn't cut it. Maybe bellows or hard covers or a combination of both. Design yet to be done! At this point still have plenty of time to think of it.
Collection, ha....ha.... i need to get rid of stuff, as the shop is full.
What did you do?
RICH