4821
General Mach Discussion / Re: Help Mach turn OD cut arc
« on: March 01, 2010, 05:53:29 PM »
What mode are you in Mach3 Turn ......radius or diameter ?
What are values based on for the inputs in the wizard ......radius or diameter ?
Did you watch the pathing moves in a dry run? The x is constantly changing as it cuts the ball.....
RICH
What are values based on for the inputs in the wizard ......radius or diameter ?
Did you watch the pathing moves in a dry run? The x is constantly changing as it cuts the ball.....
RICH