4791
General Mach Discussion / Re: I seem to be gaining steps...
« on: March 11, 2010, 07:55:18 AM »
Terry,
How to check and also setup your mill accurately is described in Using Mach3 Mill manual.
Once you have the motor tuning done and have confirmed movements, then you can try ploting out some
programs using you pen holder. Don't use it for calibrating an axis. There is a calibration feature in the Mill program.
RICH
How to check and also setup your mill accurately is described in Using Mach3 Mill manual.
Once you have the motor tuning done and have confirmed movements, then you can try ploting out some
programs using you pen holder. Don't use it for calibrating an axis. There is a calibration feature in the Mill program.
RICH