4381
LazyCam (Beta) / Re: Unrecoverable error in GI create...Notify Artsoft
« on: August 12, 2010, 06:18:31 AM »
TCUSTOMS,
Post the dxf and i will have a look .
RICH
Post the dxf and i will have a look .
RICH
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Is it possible to just purchase Lazycam pro as a stand alone package?Yes, LazyCam will post the gcode to a text file and can be run standalone. You should try LC and see if is the right software for you / your use and there are others out there which you should try, and then the choice is yours. Have a look at the last page ( 122 ) in the LazyCam Manual
Is there any trick to selecting everything within Lazycam?There are a few different ways....see page 21 of the manual....Sel in Box is one tool that you can use.
I don't have the fully licensed version of Mach3There is only one license that i know of........ie; I am not aware of a "partial Mach license".
under the impression that the free version of Mach3 R3.042.040 and Lazycam 3.01 were all that I needed to utilize the Mach3 control card I purchased with my laser