4321
General Mach Discussion / Re: AXYZ CNC router conversion
« on: September 01, 2010, 05:58:51 PM »
Don't know nothing about the toolpath software and it may be AXYZ company specific and you need to use it along with their controller.
I don't know.......
You need to find out if their controller / drives are step and direction and get specifics as to the pin outs or wiring required to use them with a different controlling program such as Mach.
May as well ask for schematics of the pendant also.
Wish Ya Luck,
RICH
I don't know.......
You need to find out if their controller / drives are step and direction and get specifics as to the pin outs or wiring required to use them with a different controlling program such as Mach.
May as well ask for schematics of the pendant also.
Wish Ya Luck,
RICH