4211
General Mach Discussion / Re: Mach problem or hardware problem?
« on: October 11, 2010, 06:04:10 PM »
nucular,
I can't duplicate on the lathe what you are experiencing. Didn't try the mill. I run my lathe and mill at max 100 IPM and the acceleration is set at
10 to 15% of the velcocity. By the time i press the reverse key ( 1/2 second maybe ) for the axis the axis has stopped. At an accel of 30% things get
unreliable ( the motors will skip). You really can't directly compare two different machnes but it gives you an a very rough idea / flavor of someone elses. A few seconds are not worth much if it creates aggrevation.......
FWIW,
RICH
I can't duplicate on the lathe what you are experiencing. Didn't try the mill. I run my lathe and mill at max 100 IPM and the acceleration is set at
10 to 15% of the velcocity. By the time i press the reverse key ( 1/2 second maybe ) for the axis the axis has stopped. At an accel of 30% things get
unreliable ( the motors will skip). You really can't directly compare two different machnes but it gives you an a very rough idea / flavor of someone elses. A few seconds are not worth much if it creates aggrevation.......
FWIW,
RICH