3851
General Mach Discussion / Re: Help ! "Radial Cut with Zdepth" toolpath from mastercam makes Skip steps ??
« on: January 20, 2011, 06:23:11 AM »
Calico,
Can you post the Gcode file your using?
There appears to be some repeatability from what i see in the pic's .The four gouge points are somewhat in the same place.
There are differences in the cutting between the pictures. If the gouge points are towards the end of the code that would indicate running time is a factor.
RICH
Can you post the Gcode file your using?
There appears to be some repeatability from what i see in the pic's .The four gouge points are somewhat in the same place.
There are differences in the cutting between the pictures. If the gouge points are towards the end of the code that would indicate running time is a factor.
RICH