3401
G-Code, CAD, and CAM discussions / Re: G40, G41 and G42 have no effect.
« on: August 08, 2011, 07:38:04 PM »
Post the dxf file generated by your program and will have a look at it in CAD and LC.
RICH
RICH
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
has a belt and it is very high tensionedIs it a timing belt or a v belt?
But now I'm running out of time.
the gcode file must, please, have been run before and tested.Really now........your time problem is not ours.........
but offsetting for cutting is my problemI generated a dxf file for the gear from two different programs and LC choked when trying to do an offset for either of them.
I'll keep it simple for now and not let my dreams go to to my head and wallet
How to use itTo Each Their Owne.................