2501
LazyTurn / Re: create new tool- grooving tool-inscribed circle
« on: August 04, 2012, 10:26:13 AM »
Fred,
I will need to do some testing to see the affects of varying parameters and that takes time, hours not minutes.
I am going to guess that using tool tip radius and inscribed circle the same value and not ticking use use tool tip radius will
work but don't qoute me on that.
Each is defined in the manual starting on page 15.
See attachment which corrects page 16 of the manual.
RICH
Quote
How is the "inscribed circle" applied to a parting tool with a 3.5mm wide tip?
I will need to do some testing to see the affects of varying parameters and that takes time, hours not minutes.
I am going to guess that using tool tip radius and inscribed circle the same value and not ticking use use tool tip radius will
work but don't qoute me on that.
Quote
In the tool setup dialog what value must i puit in inscrided circle, tip radius and flank cut depth?
Each is defined in the manual starting on page 15.
Quote
what is the significance of the size of the inscribed circle and how is it used by the program ?
See attachment which corrects page 16 of the manual.
RICH