2461
G-Code, CAD, and CAM discussions / Re: Mach3 compatible .DXF to Gcode
« on: August 23, 2012, 04:47:31 PM »Quote
would saving it as a .dxf 2012 make any difference?
No, and saving as v12 dxf is done for a reason as it more likely to be opened by the importing program and dosen't contain any
junk that is of no use for the program. As far as the drawing is concerned, I suggest you have a good read of the section on CAD DRAWING in the LC manual. LT is much better to use than LC for turning a profile as the turning in LC can be a challenge ie; see page 122 in the manual for some known problems with LC.
If i remember correctly LC posts code which is influenced by your current Mach configuration so check your configuration ie; reversed arcs and incremental / absolute come to mind.
RICH