2111
General Mach Discussion / Re: a beginner to the mach3 world is there a place here for me ? :$
« on: March 17, 2013, 10:08:58 PM »
Hey Blacky, lets play Simon Say's . That's a old game where you move as told by someone.
So it is with Gcode, you give the command to the computer and the computer tells the drive to send pulses
to the motor.
Simons says G0 Fast...... G0 is a rapid move
Simons says G1 slow ......G1 is a move at some rate G1 F20 So go at 20 inches per minute
Simons says G0 X22 so go fast in the X direction
Simon says G0 X22 Y22 So go as fast as you can in the X &Y direction
Simons says G4 P10....G4 is a dwell ( take a break for 10 seconds )
Thus Simon said to me G4 P1000000..........I really have to go bad so see ya tomorrow after i rest some
Hope you get it ......
RICH
So it is with Gcode, you give the command to the computer and the computer tells the drive to send pulses
to the motor.
Simons says G0 Fast...... G0 is a rapid move
Simons says G1 slow ......G1 is a move at some rate G1 F20 So go at 20 inches per minute
Simons says G0 X22 so go fast in the X direction
Simon says G0 X22 Y22 So go as fast as you can in the X &Y direction
Simons says G4 P10....G4 is a dwell ( take a break for 10 seconds )
Thus Simon said to me G4 P1000000..........I really have to go bad so see ya tomorrow after i rest some
Hope you get it ......
RICH