Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Filename	Downloads	Message	Posted
HCIR_Handle Crank_D.dxf	344	Re: LazyTurn	July 11, 2009, 08:22:11 AM
rmvgary3.dxf	217	HOW TO DO MULTIPLE DEPTH CUTS FOR A CONTOUR	July 09, 2009, 10:46:04 PM
jaja_jog_increments.jpg	407	Re: Hysterese	June 23, 2009, 08:46:37 PM
NOJOY_HCIR.jpg	394	Re: Problems between computer simulation and the real thing....	June 21, 2009, 08:43:55 PM
A AXIS- ROTARY TABLE SETUP.pdf	1367	Re: A Axis Setup as Degrees	June 17, 2009, 09:38:13 AM
16 SAMPLE AT 400 TIMING_HCIR1.jpg	424	Re: Problems threading on the lathe	June 05, 2009, 05:23:38 PM
64 SAMPLE AT 400 TIMING_HCIR2.jpg	393	Re: Problems threading on the lathe	June 05, 2009, 05:23:38 PM
128 SAMPLE AT 400 TIMING_HCIR3.jpg	408	Re: Problems threading on the lathe	June 05, 2009, 05:23:38 PM
512 SAMPLE AT 400 TIMING_HCIR4.jpg	463	Re: Problems threading on the lathe	June 05, 2009, 05:23:38 PM
512 SAMPLE AT 100 TIMING_HCIR4.jpg	409	Re: Problems threading on the lathe	June 05, 2009, 05:18:48 PM