This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Filename | Downloads | Message | Posted |
---|---|---|---|
tailstock_HCIR.jpg | 498 | Re: Restore Lathe Tailstock | April 19, 2011, 05:22:00 PM |
CB_CONE ON STOCK_HCIR 1.jpg | 336 | Re: I Wish There Was A Wizard For This! | April 17, 2011, 07:29:58 AM |
CB_CONE ON STOCK_HCIR 2.jpg | 432 | Re: I Wish There Was A Wizard For This! | April 17, 2011, 07:29:58 AM |
RADI COMMENT_HCIR.jpg | 444 | Re: Issue with offset | March 30, 2011, 07:20:19 PM |
MACH & FEED RATES.pdf | 627 | Re: 4th axis setup | March 29, 2011, 04:57:17 PM |
NLS_HCIR 1.jpg | 740 | Re: THE LATHE PROJECT - 2011 | March 20, 2011, 08:48:32 PM |
cncametuer_hcir.jpg | 598 | Re: Cutter compensation issues... | March 07, 2011, 06:12:22 PM |
cncameteur_hcir.dxf | 320 | Re: Cutter compensation issues... | March 07, 2011, 06:12:22 PM |
LOOP TEST CODE_HCIR.jpg | 414 | MISSING STEPS HCIR | February 27, 2011, 04:57:48 PM |
WONDERS OFF CODE_HCIR.jpg | 657 | Re: code wanders off, but only sometimes... | February 26, 2011, 06:29:45 AM |