Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Filename	Downloads	Message	Posted
SCORP CENTERED_HCIR.dxf	176	Re: Help I need to get setup!!	September 09, 2012, 09:01:11 PM
SCORP_HCIR1.jpg	417	Re: Help I need to get setup!!	September 09, 2012, 09:01:11 PM
MISSING SOMETHING.jpg	454	Re: Mach3 not following path just cuts circles	September 06, 2012, 06:29:30 PM
LatheDennis_HCIR.xml	138	Re: re:CNC Lathe program	August 10, 2012, 05:37:52 AM
dennis 1_hcir.doc	1065	Re: re:CNC Lathe program	August 08, 2012, 05:25:58 PM
THREE BALL FOR DENNIS.txt	170	Re: re:CNC Lathe program	August 06, 2012, 05:44:16 PM
THREE BALLS for dennis.dxf	132	Re: re:CNC Lathe program	August 06, 2012, 05:44:16 PM
page 16.jpg	742	Re: create new tool- grooving tool-inscribed circle	August 04, 2012, 06:45:52 PM
Inscribed Circle_PAGE 16 UPDATE.pdf	473	Re: create new tool- grooving tool-inscribed circle	August 04, 2012, 10:26:13 AM
ballend_hcir.jpg	716	Re: battling with dxf	July 31, 2012, 07:15:50 PM