This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Filename | Downloads | Message | Posted |
---|---|---|---|
88SQUARE_HCIR.dxf | 200 | Re: Help I need to get setup!! | September 10, 2012, 06:09:00 PM |
draft USING THE WIZARD FOR NPTF THREADING.pdf | 1438 | NPT THREADING ON THE LATHE - USING THE SIMPLE THREADING WIZARD | September 16, 2012, 10:39:20 AM |
G28G30.pdf | 285 | Re: a few questions aboput tool table setting up | September 17, 2012, 06:30:31 AM |
G28G30_hcir.pdf | 212 | Re: using M30 to go to home position | September 27, 2012, 05:53:24 PM |
ORIGIN AS DRAWN_HCIR.jpg | 634 | Re: No Mach3 Found Running | September 29, 2012, 05:50:44 AM |
MOVING THE ORIGIN _HCIR.jpg | 544 | Re: No Mach3 Found Running | September 29, 2012, 05:50:44 AM |
CONFIRM ORIGIN _HCIR.jpg | 582 | Re: No Mach3 Found Running | September 29, 2012, 05:50:44 AM |
LEAD IN _HCIR.jpg | 580 | Re: No Mach3 Found Running | September 29, 2012, 05:55:47 AM |
MOVE CUTTING START POINT_HCIR.jpg | 509 | Re: No Mach3 Found Running | September 29, 2012, 05:55:47 AM |
text_hcir1.jpg | 744 | Re: No Entities Shown | October 18, 2012, 05:37:04 PM |