Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Filename	Downloads	Message	Posted
HCIRcoté modifié avant.dxf	213	Re: offset problems	October 11, 2010, 06:40:23 PM
SCREW MAPPING_HCIR.jpg	543	Re: Axis length movement profiling / mapping ?	October 11, 2010, 08:43:19 PM
GM CODE_HCIR.doc	568	Re: Code conversions	October 20, 2010, 05:46:55 AM
Mach3_lathe_roughing_and_finishing_macros_HCIR.zip	754	MACRO- LATHE - ROUGH & FINISH OD - BORING - FACING	October 21, 2010, 10:23:24 PM
YOUR CALC_HCIR.jpg	13659	Re: steps per calculation (Help with)	October 27, 2010, 08:04:28 PM
6WIRE_HCIR.jpg	469	Re: Sherline rotary table on a 3 axis mill running Mach3.	October 29, 2010, 06:13:16 AM
Top Panel _HCIR 12 12.dxf	187	Re: Lazycam Help, Tool Compensation.	November 10, 2010, 09:30:17 PM
HCIR LC 12 12.LCam	208	Re: Lazycam Help, Tool Compensation.	November 10, 2010, 09:30:17 PM
Top Panel _HCIR LC 12 12 3 cut.LCam	192	Re: Lazycam Help, Tool Compensation.	November 10, 2010, 09:30:17 PM
TopPanel_HCIR 12 12 3 cut.txt	225	Re: Lazycam Help, Tool Compensation.	November 10, 2010, 09:30:17 PM