6
« on: June 25, 2008, 11:15:23 AM »
Its about 1.5 revs of the motor, 48 steps per unit. And it really is not a stutter the motors actually stop completely then start again over and over. I dont even have it hooked up to a machine yet I am just testing it first. I just have my motors side by side on my bench. If you tell it to rapid a few inches it will start to rotate then stop then start again, it looks like a certain increment before it stops, until it finally gets to where it is going. And yes all axis stop and the same time when running both at the same time. If a single axis move just that axis stops obviously. What is weird is that it will jog just fine even multiple axis at the same time. Its just when running code. I had this problem the other day and I messed with the motor tuning settings and it quit. At least thats what I thought helped it.
Thanks