Messages

31

General Mach Discussion / Re: Changed computers, can't get kboard working. Help!

« on: June 22, 2008, 09:02:09 PM »

direction pin for x is 6. about to test. can you hold one of these.

32

General Mach Discussion / Re: Changed computers, can't get kboard working. Help!

« on: June 22, 2008, 08:56:06 PM »

TAking the cable lose won't blow a Gecko will it?

33

General Mach Discussion / Re: Changed computers, can't get kboard working. Help!

« on: June 22, 2008, 08:53:42 PM »

Your just too fast for me. While I get my voltmeter can you tell me which 2 pins?

34

General Mach Discussion / Re: Changed computers, can't get kboard working. Help!

« on: June 22, 2008, 08:52:04 PM »

Does this look right?

35

General Mach Discussion / Re: Changed computers, can't get kboard working. Help!

« on: June 22, 2008, 08:49:12 PM »

Gonna look for an image of a cable on Google. If you need to go we can pick it up tomorrow or whnever.

36

General Mach Discussion / Re: Changed computers, can't get kboard working. Help!

« on: June 22, 2008, 08:46:02 PM »

PS: I did set up the icon on the desktop. And I pasted in the edit.

37

General Mach Discussion / Re: Changed computers, can't get kboard working. Help!

« on: June 22, 2008, 08:44:10 PM »

No. I doesn't respond to MDI. It did when this sad tale began a few hours ago. The keyboard wouldn't work but it would respond to commands typed in. However, the DRO does reflect a lift of one inch of the Z even though it never happened. I did hear a stepper thud.

38

General Mach Discussion / Screenshot

« on: June 22, 2008, 08:37:40 PM »

Here it is:

39

General Mach Discussion / Re: Changed computers, can't get kboard working. Help!

« on: June 22, 2008, 08:33:16 PM »

Yes, of course. Please don't keep after this if you're sick of it and want to take a break. I'll get busy on the post.

40

General Mach Discussion / Re: Changed computers, can't get kboard working. Help!

« on: June 22, 2008, 08:29:16 PM »

"Not wanting to further confuse the situation but can you type in a line of g-code and get the motors to move? Been following this for hours."

It would the last time I tried. The only thing it wouldn't do is to respond to the jogging keys.