Hello Guest it is July 17, 2019, 11:19:45 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - inivator

Pages: « 1 2 3 4 5 6 7 8 9 10 11 »
71
General Mach Discussion / Re: Limit Switch Problems
« on: June 30, 2008, 01:48:14 PM »
Thanks you very much, again. I hope this is the end of my stupid questions...............

Inivator

72
General Mach Discussion / Re: Limit Switch Problems
« on: June 30, 2008, 01:24:36 PM »
How do I do the reference procedure?

73
General Mach Discussion / Re: Limit Switch Problems
« on: June 30, 2008, 11:38:39 AM »
From the MDI screen, will G28 send the axis to home.

74
General Mach Discussion / Re: Limit Switch Problems
« on: June 30, 2008, 11:33:44 AM »
Thanks  you sir....................

Inivator

75
General Mach Discussion / Re: Limit Switch Problems
« on: June 30, 2008, 10:44:18 AM »
Hood sent a screen shot of the setting I need, but I did not understand his direction.  My machine is x=40, y=16.5, and z =4.  x0 and y0 are in the left hand corner. Can someone send me a screen shot with the correct setting.  Z down is -.

Thanks

Inivator

76
General Mach Discussion / Re: Limit Switch Problems
« on: June 29, 2008, 02:01:24 PM »
I'M SORRY HOOD, I ON A DIFFERENT COMPUTER.....THIS IS INIVATOR

77
General Mach Discussion / Re: Limit Switch Problems
« on: June 29, 2008, 01:45:39 PM »
COULD YOU PLEASE SEND ME A SCREEN SHOT OF THE HOMING AND LIMITS.

78
General Mach Discussion / Re: Limit Switch Problems
« on: June 29, 2008, 10:51:37 AM »
Thanks for the help Hood, I try everything you have told me, and will let you know the outcome.

Again, thanks...........

Inivator

79
General Mach Discussion / Re: Limit Switch Problems
« on: June 29, 2008, 10:33:25 AM »
X is in the lower left hand corner, and Z is full up.........

80
General Mach Discussion / Re: Limit Switch Problems
« on: June 29, 2008, 10:23:52 AM »
Home switches are in a - relation to table..  Also, where are the reference buttons?

Pages: « 1 2 3 4 5 6 7 8 9 10 11 »