Hello Guest it is September 27, 2020, 10:01:42 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - najnielkp

Pages: « 1 2 3 4
31
General Mach Discussion / referencing not working in mach 3
« on: September 19, 2006, 08:06:40 PM »
i have a problem with mach 3 referencing to home. using input pin 11 for x, pin 12 y,pin 13 z. when referencing ,mach 3 hits the limit and the estop trips, does not back off the switch. i hve to switch off motor power and hand crank off the switch. limit overide does not work. the estop wont reset.

tried this setup with mach 2 and works no problem.


32
General Mach Discussion / Re: gcode edit
« on: September 10, 2006, 03:05:40 PM »
thanks, i wil try it tomorrow.

33
General Mach Discussion / gcode edit
« on: September 10, 2006, 06:56:00 AM »
hello all,

i am a new user of mach 3. i have a problem with editing gcode. when i click on the icon , nothing happens. i have to open up with notepad manually. is this function disabled?


Pages: « 1 2 3 4