41
General Mach Discussion / saving work offsets
« on: May 14, 2008, 05:28:56 PM »
Every time I start Mach3 I have to re-enter all the work and tool offsets. I put them into Mach3 with the G10 command and can use them untill I re-start Mach3. When shutting Mach3 down I always get asked if I want to save the settings, I click to save.
I'm using WinXP original version (no service packs).
Can anyone tell me how to me how to make Mach3 remember all the offsets?
I'm using WinXP original version (no service packs).
Can anyone tell me how to me how to make Mach3 remember all the offsets?