Messages

141

Newfangled Solutions Mach3 Wizards / Re: V2.82 ready for test, also for Tormach users

« on: December 10, 2008, 08:12:19 AM »

I tried the Preview on Circle Pocket and Cut Rectangle, and they generate correct Gcode  to Mach3.
HTH
Troy

142

Newfangled Solutions Mach3 Wizards / Re: V2.82 ready for test, also for Tormach users

« on: December 10, 2008, 07:24:26 AM »

Doing a Tread Mill wizard.... M6 T? ,Spindle direction,and Coolant function, all disappear after previewing twice.

All other fixes look good
HTH
Troy

143

Newfangled Solutions Mach3 Wizards / Re: V2.81

« on: December 08, 2008, 10:53:41 AM »

Found out why CW and CCW is backwards  I was reading description beside the CW & CCW,that is what is backwards, but when selectting CW or CCW and not going by description,program is right.
Sorry for not paying attention.
Troy

144

Newfangled Solutions Mach3 Wizards / Re: V2.81

« on: December 08, 2008, 06:53:19 AM »

Checked wizard version and is 2.81.Mach version is 3.038.
Thanks,
Troy

145

Newfangled Solutions Mach3 Wizards / Re: V2.81

« on: December 04, 2008, 01:24:37 PM »

Cut rectangle..
The preview does not show what you have in Peck distance.Looks like it defaults to .100.But shows fine in Mach.

Circle pocket..
The CW and CCW directione is backwards to what is selected.

Thread Mill..
There is no M6 or T
And no feedrate.

HTH
Troy

146

Newfangled Solutions Mach3 Wizards / Re: Rectangle wizard not putting out feed speeds. 2.79 bug?

« on: November 26, 2008, 02:01:04 PM »

Also noticed in 2.80. When doing an outside Rectangle that tool comes out of part turns off comp then back on and then tool goes back down to do next pass depth.
Troy

147

Newfangled Solutions Mach3 Wizards / Re: Rectangle wizard not putting out feed speeds. 2.79 bug?

« on: November 26, 2008, 01:40:01 PM »

Soory made a typo Should have been 2.78 not 2.79. But feedrate problem is in 2.78 also.
sorry again,
Troy

148

Newfangled Solutions Mach3 Wizards / Re: Rectangle wizard not putting out feed speeds. 2.79 bug?

« on: November 26, 2008, 10:30:55 AM »

Version 2.79 comps just fine,and plunge feedrate and cut feedrate are both there.But the Preview is wrong,as u stated u need to fix.
HTH
Troy

149

Newfangled Solutions Mach3 Wizards / Re: Rectangle wizard not putting out feed speeds. 2.79 bug?

« on: November 26, 2008, 09:07:59 AM »

Inner Climb Cut rectangle does not preview while in wizard.But does in Mach3.Before first run of program there is a very wacky comp move,but when i stop then reset program and regen toolpath the comp then works fine.
HTH
Troy

150

Newfangled Solutions Mach3 Wizards / Re: V2.79

« on: November 19, 2008, 07:02:34 AM »

The 2 depth DROs must have been a glitch in screens,because it has went away.
Thanks,
Troy